 |
 |
|
These steps will allow you to connect a Honeywell HMC6352 compass to the [LabVIEW for the ARM microcontroller LM3S8962] and diplay the heading in degrees on the front panel.
1 Get a LM3S8962 board and HMC6352 Compass.
how to buy a [LabVIEW for the ARM microcontroller LM3S8962]
Compass:http://www.sparkfun.com/commerce/product_info.php?products_id=7915
Note: The datasheet for the compass is available on the page linked here.
2 Install software and create a project for the [LabVIEW for ARM microntroller LM3S8962].
http://decibel.ni.com/content/docs/DOC-6233
3 Wire pins 47, 48, 57, ad 60 on the LM3S8962 to the compass as shown below.
4 If you are using Labview 2009 simply copy and paste the picture of the code below into your block diagram; otherwise, the VI is attached to this document.
There are no comments on this document
Legal
This content (includes attachments) has been made available by community members, whom are solely responsible for such content. National Instruments does not support this content, and does not guarantee its quality in any way. NATIONAL INSTRUMENTS MAKES NO WARRANTIES, EXPRESS, STATUTORY OR IMPLIED, WITH RESPECT TO THIS CONTENT, INCLUDING WITHOUT LIMITATION ANY WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, TITLE, NON-INFRINGEMENT OF INTELLECTUAL PROPERTY, OR ANY OTHER WARRANTIES THAT MAY ARISE FROM USAGE OF TRADE OR COURSE OF DEALING. For details regarding support of such content, please contact the author. For further legal information, please visit http://ni.com/legal/termsofuse/unitedstates/us/.