Example Code

Change Line Names on Digital Waveform Graph Programmatically

Products and Environment

This section reflects the products and operating system used to create the example.

To download NI software, including the products shown below, visit ni.com/downloads.

    Hardware

  • Data Acquisition (DAQ)

    Software

  • LabVIEW

    Driver

  • NI DAQmx

Code and Documents

Attachment

Overview
The example demonstrates how to alter the line names of digital waveforms within the block diagram of the LabVIEW

Description:
This simple VI would shows you a basic flow to change the digital line names

Steps to implement or execute code
To implement this example:

  1. Change the channel parameters as needed
  2. Run the VI
  3. (Optional) Turn on the Highlight Execution to see the flow of the VI

To execute this example:

  1. Install the required software.
  2. Connect the DAQ hardware that supports the DIO features
  3. Confirm the connection with the MAX with TestPanel
  4. Open the VI and refer the Implement Steps


Requirements
Software
LabVIEW 2012 or compatible
NI-DAQmx 16.0 or compatible

Hardware
cDAQ with C series Digital Input Output Module

 

bd.JPGfp.JPG

**This document has been updated to meet the current required format for the NI Code Exchange.**

Best regards,
Rohan B

Example code from the Example Code Exchange in the NI Community is licensed with the MIT license.

Comments
aschipfl
Member
Member
on

Is there also a similar way to set/change the names of busses in digital waveform graphs?