Skip navigation

Community

Currently Being Moderated

DAQmx Example: Changing or Verifying Calibration Password on a DAQ device

VERSION 1 
Created on: Apr 26, 2011 11:25 PM by Jim_S - Last Modified:  Apr 26, 2011 11:25 PM by Jim_S

Introduction:

In this example it will explain how to change or verify the password for the calibration information on a DAQ device in DAQmx.

 

Steps to Code:


1.) Waits for the user to provide the information to check/change the calibration password.

2.) Opens a connection to the calibration information in order to check the password.

3.) Closes the calibration session.

4.) Changes the password if it has been provided the correct original password.

5.) Provides the user a customized error explaining if the password was incorrect or if the device wasn't recongized

6.) Presents the errors.

 

Testpassword.png

Attachments:
Comments (0)