Home Community Example Programs Example Code Document

Example Code

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
ASK A QUESTION

Transfer Graph to a Sub VI

by: Member
‎06-19-2011 02:43 PM
Last Edited by: Member Example_Scrubber_Suryo ‎11-01-2017 03:36 AM

Products and Environment

This section reflects the products and operating system used to create the example.

To download NI software, including the products shown below, visit ni.com/downloads.

    Software

  • LabVIEW

Code and Documents

Attachment

Download All

Overview
To transfer waveform graph data to and from one another.

Description:
These VIs allow you to transfer waveform graph data to and from one another. The main VI (InputData.vi) generates two different waveform data. Then transfers data to different waveform.

Instructions:
To implement this example:

  1. Run the VI
  2. Turn On the Transfer to Transfer the Graph


To execute this example:

  1. Install the required software.
  2. Open the VI and refer the Implement Steps


Requirements
Software
LabVIEW 2012 or compatible

Hardware
-

bd.pngfp.PNG

**This document has been updated to meet the current required format for the NI Code Exchange.**

Best Regards,
Jignesh Patel
Principal RF Software Engineer

Example code from the Example Code Exchange in the NI Community is licensed with the MIT license.

0 Kudos