I want to use LV embedded for ARM7 LPC2119, what first i want to do,and how to do it?

[kaney4115]

i want to port labview program to my target LPC2100,such as LPC2119.But i do not know what i should do first,and how to do it? second,third.......please give me some help.

[Marker_LV]

me too~!!!  I'm lpc2103 ,many issue many time ,it don't work now。。。。。

[timtamslam]

The LPC2119 and LPC2103 processors full under the Tier 2 category of supported devices. Keil's uVision toolchain does support these targets (you can confirm that from this list, http://www.keil.com/dd/) but there is some additional porting steps that need to be taken in order to program these devices using the LabVIEW Embedded for ARM module. 

The steps you need to take are explained starting on this document, 

LabVIEW Embedded for ARM Porting Guide - Chapter 1: Introduction

http://www.ni.com/white-paper/6994/en

And continues for a total of 5 chapters. Please note, this is not a short process and the process is even longer if you are not familiar with microprocess programming and software development. 

[Marker_LV]

thank dear engineer .i while try again tomorrow