04-27-2014 09:35 PM
Hi everyone,
I want to get the phase difference of two analog signal by Labview interface for Arduino.
I am a new Labview user and I tried to program a programming, but I am not sure whether it is correct.
Can anyone help me to have a look?
VI is attached below.
Thank you!
04-28-2014 03:00 AM
What are the frequencies of the two analog waveforms for which you are trying to determine this information?
04-29-2014 04:47 AM
Hello Nathan,
Thank you for your reply.
Two analog waveforms have the same low frequency. I can read and display them on the waveform chart.
What I care about is just whether the programming of calculating phase difference is correct?
04-29-2014 01:18 PM
Since your question is not specifically about LIFA (you are asking about data processing and not data acquisition with Arduino), you would probably have better success by posting in the general forums.