Hello everyone,
I know this post is old, but if someone could help me I would be very thankful.
I´m making a very similar project, because I need to control three stepper motors with LabVIEW. The difference is that I´m using LINX, so I can´t declare pins (I think that´s not posible in LINX).
I think I just have to write in the pins where the steppers are connected, but I don´t know what pins are because stepper is wired to an A4988 driver, and the driver is connected to the RAMPS 1.4.
If someone knows another way to do that with LINX, or realizes a mistake I could make, please say to me.
Thanks a lot!
