stepper motor interface with labview and arduino

[Zahkay]

Hello everyone

i am having problem with my coding. I have to make the stepper motor rotate accordingly. i am sorting object where specific QR code are stick on it.

However, when the qr code on the object is scanned, the motor should rotate to a certain degree and then go to the home position. and when scan another object, it should rotate as well and then return to the home position.

when i am trying it in my GUI, like with the scanning all that. it is not working properly

But i did try my motor circuit with the lIFA for the example of stepper in the labview which work perfectly. when i give a certain angle, the motor rotate.

Can some1 help me please. i will be really grateful.

My GUI and image processing for the QR code is in labview where i use vision acquisition and Vision assistant to make it work,

[Danubio]

Hi Zahkay,

Since arduino is a third party device and the features provided to interface with are too, National Instruments doesn't bring support to it. That why I would like to strongly recommend you to please redirect this question but in the LabVIEW discussion forums rather than here in the community. For doing that follow this link:

http://forums.ni.com/

You can also type arduino in the search bar of that section of the website and try to search for a similar case to discuss or compare better your case.

That is because you will be interacting with a lot of experienced users that can orient you to develop your application.

Best regards

[Zahkay]

Dear Sir

thank you for replying, i try to put it here. is it okie now sir

http://forums.ni.com/t5/LabVIEW/stepper-motor-interface-with-labview-and-arduino/td-p/2828596

Hope to hear from you soon

Best Regards