04-26-2017 05:56 AM
Q1:As is shown in the picture below,how can I change the range -32768~32767 to -10~10 ? Please provide me with detailed solutions,thanks a lot !
Question2:As is shown in the program below,how can I set the parameters of sine wave and square wave so that I can see both of the two signals in the scope at the same time.
04-26-2017 08:14 AM
04-27-2017 04:54 AM
Q1:I want to measure the voltage ranging from -10v~10v,not -15~15.May you help me?
Q2:I can't see both of the two signals at the same time in one signal even though I've tried many times.However,I can only see one signal if I change the labview program.
04-27-2017 05:59 AM
Your ADCs will deliver values in the range of +-16368. If you need to scale these to +- 10V then you need to divide these numbers by 1636.8.
The values returned from the node you are using are not physical units, they are binary representations of the output of the ADC.
04-27-2017 06:17 AM
Hi emailjhd,
Q2:I can't see both of the two signals at the same time in one signal
How do you want to "see two signals in one signal"???
even though I've tried many times.
What have you tried (many times)?
However,I can only see one signal if I change the labview program.
How did you change your program? Which signal do you see then?
04-27-2017 06:32 AM
Hi, Intaris,
Thanks for your reply! I know what you mean.My teacher asked me to change the values -32768~32767 to -10~10V in the picture as follows,so I believe there exists solutions to my problem.If convenient,please provide me with program.
Best wishes
emailjhd
04-27-2017 07:01 AM
04-27-2017 07:39 AM
Hi GerdW,
I am a new one here and feel sorry to disturb you.
04-27-2017 07:48 AM - edited 04-27-2017 07:48 AM
Have you looked at the "Data Entry" tab?