12-04-2014 02:58 AM
Hi
Another problem, hopefully small (but seeming big)
I tried to configure Compact RIO(9103) with a Digital output module(9472) for PWM. The error :
" Project DIO mode is PWM; System DIO mode is Normal
"Project PWM frequency is 50 Hz; System PWM frequency is 1 KHz" pops up when I run the VI and deployment fails.
I am unable to rectify this. I think this has to do something with the IP address to which I configured the cRIO. I configured it to an address which was present by default when I connected it to the system. MAX shows "connected- running" as the status and also says running properly.
Please help me out.
Thanks in advance.
Lahari
12-05-2014 08:21 AM
Friends...Please help me...