04-03-2007 09:48 AM
04-03-2007 09:50 AM - edited 04-03-2007 09:50 AM
http://forums.ni.com/ni/board/message?board.id=170&message.id=239407
Message Edited by James R on 04-03-2007 09:54 AM
04-03-2007 10:11 AM
04-03-2007 10:14 AM - edited 04-03-2007 10:14 AM
you can't cut and paste one case and insert it into another but you can cut and paste the contents of the case.
try to just select the code inside of the case
when you paste it inside the case the case may autosize and screw up your format so try pasting it into the white space outside of your code and then dragging it inside the destination case
you will have to reconnect the wires that connect to the terminals on the right side of the case
Message Edited by James R on 04-03-2007 10:17 AM
04-03-2007 10:17 AM
04-03-2007 11:52 AM
The problem is not a bug.
As Lyn has said, each variable that's recreated is in duplicate so there seems to be no choice other than to edit the resultant Block Diagram and Front Panel after cutting and pasting.
04-03-2007 12:00 PM
04-03-2007 12:05 PM