Analog Output Voltage non-zero (using a pxi-8336)

[MikeHahn]

Earlier I posted a question about the voltage being too high for the first second of a programmed output.

The actual problem seems to be that the output from the analog out is always some non-zero voltage. There are two analog outputs on the card, the first has an output of 0.98 V and the second has an output of 0.5 V, which is constant all the time.

I have tried turning the chassis off and on, and resetting the device in "Measurement and Automation Explorer".

"Measurement and Automation Explorer" has a window in which you can set the base output voltage, that voltage is set to zero. Even if it were set to a different value that would not explain why one channel should be at 1V and the other at 0.5V.

Thanks for any help.

Mike

[Simran_K]

Hey Mike,

If you can, please continue to post on your original post. Please reference your original post for further information.

Thank you,

Simran K.





Message Edited by Simran_K on 06-11-2008 01:16 PM