05-30-2014 12:04 PM - edited 05-30-2014 12:10 PM
hello,
I'm quite new with using Labview and i have a problem that i deal with for a long time. I have a NI 9232 module and i have to aquire data using cRIO. I have to measure 256000 samples with a sampling rate of 25.6 kHz. So far i managed to measure only 1000 samples. From what i have already read i think it has something to do with the FIFO but i can't figure out how to solve the problem.
I already read the forum post here: http://forums.ni.com/t5/Real-Time-Measurement-and/1-MS-s-with-cRIO-FPGA/m-p/2241746/highlight/true#M... but i do not quire understand how to implement it. If needed i can post the vi.
06-02-2014 03:47 PM
GrigS,
What part are you finding difficult to understand? Was there something in the whitepaper that the thread pointed to that was unclear?
http://www.ni.com/white-paper/4534/en/