05-18-2011 02:03 PM
Hi everybody. Somebody can help my with this IMU? I connected to the computer and I tried to run the LabView example Microstrain 3DM-GXx, and I couldn't obtain data from the IMU with the example.
Solved! Go to Solution.
05-20-2011 09:58 AM
Greetings, are you getting any error messages? How are you communicating with the device? (Serial, GPIB, USB, etc)
05-23-2011 07:30 AM
The 3DM-GXx drivers were written for MicroStrain's 3DM-GX2 and Inertia-Link products. The drivers do not work on the 3DM-GX3-25 because the communication commands are different. LabVIEW drivers may be downloaded with the 3DM-GX3-25 SDK available on the MicroStrain web site http://www.microstrain.com/updates/GX3_Orientation_SDK.zip.
05-24-2011 02:20 PM
Ah, thank you for providing that information.
05-23-2012 10:39 AM
Does anyone have the drivers for the 3DM-GX3 -45? I don't want to reinvent the wheel if someone already created the LabVIEW code for it.
Thanks in advance!
05-24-2012 10:18 AM - edited 05-24-2012 10:18 AM
Lisa7603,
The drivers for the 3DM-GX3-45 are available from the same microstrain site referenced in the previous post.
http://www.microstrain.com/software-updates
Should be towards the bottom.
Regards,
05-24-2012 10:22 AM
Chris,
I am talking about the LabVIEW code. The 3DM-GXx project does not work with the GX3 -45.
Thanks,
Lisa
05-25-2012 04:33 PM
Lisa,
Where is the 3DM-GXx project that you are trying to use? Is it an example from the NI website or one provided by Microstrain?
Regards,
04-08-2013 03:46 PM
Well, I couldn't use this driver. It is not working...
04-09-2013 07:16 AM
LabVIEW sample code for the MicroStrain 3DM-GX3-45 may be downloaded at this link: http://files.microstrain.com/MIP%20LabVIEW%20Sample%20Code.zip. The Data Communications Protocol manual may be downloaded at this link: http://files.microstrain.com/3DM-GX3-45-Data-Communications-Protocol.pdf. The LabVIEW sample code is written using the instructions for commands and responses found in the Data Communications Protocol manual.