Hi,
You will not be able to use the counter directly but you can setup an analog level trigger for your signals. This will create a pulse that isTTL compatible for you everytime the signal crosses a particular level. Then you can route this into your counter and perform any counter measurements on it. An example is this is shown
here where it sets up a level trigger to make frequency measurements.
Alternatively you can purchase an industrial strength digital I/O board such as the USB-6525 but this does not include a counter.
Please let me know if this works out for you.
Message Edited by Abhinav T on 07-06-2007 05:20 AM
Abhinav T.
Applications Engineering
National Instruments India
LabVIEW Introduction Course - Six Hours
Getting Started with NI-DAQmx
Measurement Fundamentals