trying to trigger multiple analog measurements with each pulse of a 500PPR encoder

[LabTech09]

I am trying to take multiple analog measurements form 6 sensors with each pulse of a 500 ppr encoder and write these to a file.  Problem I have run into is I am not getting 500 readings with 1 revolution of the encoder the most I have received is 187 however this isnt consistant.

using

6024 E Series card

BEI L25G encoder

Still relatively new to labview along with using an older version 7.0

Thank You in advance

[LabTech09 · Accepted solution]

Never mind after looking at it somemore i found i was using the wrong sample rate