04-30-2014 12:58 AM
Hello,
I'm really new to Labview and trying to make a program that increases the output voltage overtime using my DAQPad-6259. Basically I want to start from a certain voltage and then given a specific time interval, the voltage will increase at a certain rate. Ideally I want to go up and down a certain voltage range if it's possible. Like say the voltage will go up and down from -5V to 5V at a certain rate until I tell it to stop.
I tried making a lousy excuse of a program using LabView 8.5, but the output doesn't change.
I'd greatly appreciate whatever help that you guys might be able to extend. Thank you.
Cheers,
rakue
05-01-2014 11:13 AM
Hi Rakue,
What version of DAQmx are you using? Have you looked into the onboard examples (Help > Find examples) to try and find an analog output example?
Regards,