sbRIO starting point

[deamonata]

Hi there,

I'm currently trying to figure out how to interface with an sbRIO, I am part of a team that is trying to design a small robot capable of collecting a series of balls. the main controller code I'm ok with, however I'm not sure how to send out/recieve a signal using the sbRIO. I was wondering if anyone could point me in the right direction.

Thanks

George

[Chris_Jones_NIUK]

Hi George,

Welcome to the NI Discussion Forums!

Could you give a little more information on what exactly you are trying to do?

• Are you having trouble accessing the I/O of the sbRIO?
• If this is the case, is it for the hardware of software side of things?
• What kind of signals are you looking to interface with?
• What model sbRIO do you have?

It is also worth noting that the architecture of the sbRIO is very similar to that of a cRIO. As such, much of the documentation for the cRIO will also be relevant to sbRIO.

A good starting point would be here: http://www.ni.com/singleboard/setup/