ni.com checkout is currently experiencing issues.
Support teams are actively working on the resolution.
ni.com checkout is currently experiencing issues.
Support teams are actively working on the resolution.
06-27-2013 04:26 PM
Using the above information I was finally able to get the arduino side compilation errors to go away. However, when I try to open the VI, I get the following error:
LabVIEW load error code 9: VI version (11.0) is newer than LabVIEW version (10.0f2).
I am using the student version of labview 2010. How can I open this VI? Can you save a version that is compatible with older versions of LabVIEW or am I making some other mistake?
06-27-2013 05:55 PM
Which VI are you referring to? Could you attach the VI to your next post? I should be able to convert it for you.
06-27-2013 06:06 PM
Thanks for your fast response. I the file I wasn't able to open was the one from this post. I looked at another forum and found a different copy of the file that was compatible with my older LabVIEW files. Thanks again!
06-29-2013 11:25 PM
He I solve my problemI use the LIFA SRF05 LV9.zip
in this pag
https://decibel.ni.com/content/message/38645#38645#38645
and work perfect
I hope help with this page
08-21-2013 02:55 AM
Hi..
I really got confused to work with Arduino Uno + Labview + Ultra sonic Sensor (HC-SR04).. I am using Labview 2012 version and my arduino version is 1.0.5. To Interface My Ultrasonic sensor and Arduino kit with labview what should i do initialy ??? I have attached the Ultrasonicsensor.vi image file. To this .vi file What should be my Firmware data ? Where i can get it ? I tried lot of .pde and .h file but it went fail.. My goal is to find distance using Arduino kit & Ultrasonic sensor in labview platform..
Looking for kind help.
..................................................................................................................................
Regards
Gokul
08-21-2013 03:10 AM
I gokul2013
Did you saw this site?
http://vishots.com/getting-started-with-the-labview-interface-for-arduino/
Best regards
cpalha
08-21-2013 03:26 AM
Thanks for your Quick response
Ya. I saw. But it is apart from my application know. Also i followed all the steps what i saw in that link http://vishots.com/getting-started-with-the-labview-interface-for-arduino/... I found that Firmware folder and i uploaded that sketch file into my Arduino uno kit. when i use that ultrasonic vi file. its not working..??
08-21-2013 07:15 PM
The default firmware will not work for this particular sensor. Have you tried my custom firmware and VI in this thread?
08-22-2013 03:31 AM
Thanks
Now its working fine.. Thanks a lot.
08-28-2013 06:10 AM
I uploaded your modified firmware in my Ultrasonic Sensor and i run your corresponding .vi file. It greatly working on first time. but when i stop and run again. the Rx LED in my sensor only blinking and vi generates error 5002. Then i uploaded firmware and again run. as usual it working fine on first time but not in second time. What is the problem with it..??? Looking for your reply..