05-12-2017 06:31 AM - edited 05-12-2017 06:54 AM
Hi,
I have a problem with the ultrasonic ( HC-SR04) .. it's my first time to use Labview
first i'm using labview 2015 version and Arduino IDE version 1.6.9
The problem is i tried to test the sensor and make sure that i can calculate the distance using the interface between labview and arduino ,so i used a simple program shown below using the sensor uploaded in this topic ..
https://forums.ni.com/t5/LabVIEW-Interface-for-Arduino/LIFA-Ultrasonic-Distance-Sensor/ta-p/3514004
But the indicator does not show anything !!
knowing that i installed the VISA program and arduino board works well and i uploaded the LIFA Base code before using it and i tried simple program to blink a led and it works !!
Here screenshots : first labview program and its output
and the same program using arduino IDE to calculate the distance
and sorry for my bad language
thanks,
Labview program:
The Sensor Works well !!!
Solved! Go to Solution.
05-15-2017 09:11 PM
I highly recommend using LINX with this fixed VI. If you have further issues with this method, please create a thread on the LINX forum.
05-18-2017 12:27 PM
ok i will try thank you so much 🙂