Hi there!
I'm very new to both Arduino and LV. I should couple them for a thesis. Until now I thought the installation process was relatively simple but now I really got stuck...
I followed the well known tutorial for the installation and the first blinking example: http://www.youtube.com/watch?v=RGRhIQneO6w
I can make pin 13 blink using arduino IDE but not using LabView. When I run the program, I can see the data transfer is happening but the LED on the board does not blink afterwards.
Looks like a communication problem:
- I have a Arduino Pro. I've read that only UNO is supported an in LabView I can only chose between Uno/Dimuelanove/Mega 2560.
However I've seen a guy reading an accelerometer using LV and Arduino Pro. The problem is I don't have his contact...
- In windows device manager under Ports (COM & LPT) the port is not named "arduino" but just USB Serial Port (COM4). Can this be the cause of my problem?
I really hope that anyone has a hint for me... I'm totally lost