09-11-2014 07:53 AM
I want to use quick CAN for the project using LabVIEW .So I need the device driver for Quick CAN so that ,I can interface with LabVIEW.Is there a Driver for Quick CAN for LabVIEW ?
Some Detail on Quick CAN
http://qprotos.com/quickcan.htm
09-11-2014 08:18 AM
Hi Sibin,
you already asked the very same question in the LabVIEW API blog.
Didn't you like my answer?
09-11-2014 09:40 AM
Wow that looks like a piece of junk. You get what you pay for, and that goes for driver support as well. If you bought a NI CAN device or XNET you'd have all kinds of support from this forum trying to help you out. Heck even a Vector device has some love on this forum. And Intrepid has drivers for their hardware in LabVIEW...it needs some attention but it exists.
I say read the documentation, write a set of VIs to talk to the device, and post here if you have any general questions about writing drivers.
Unofficial Forum Rules and Guidelines
Get going with G! - LabVIEW Wiki.
16 Part Blog on Automotive CAN bus. - Hooovahh - LabVIEW Overlord
09-11-2014 09:57 AM
09-11-2014 11:04 PM
I am sorry GerdW, its nothing like that .I was just see my luck, if i could get the device driver. And yes ,I have less experience in CLFN.