I have a oscilloscope that supports GPIB interface.Is it possible to connect this to labview and obtain a live signal?

[Cresmech]

i am working on a project where it is necessary to capture a live signal from a accoustic sensor using a oscilloscope...the oscilloscope is a AGILENT 54621A ( 60 MHz, 200 MS a/s) which has a gpib support...can someone please tell me the way i can connect the oscilloscope to labview and capture the live signal so as to process the sound waves obtained... please tell me the step by step procedure

[Ray.R]

When you installed the drivers for the scope, it usually has example code with it, such as "Getting Started".  Have a look for it and try it out. It's a good starting point.

[Meghan R]

Hello Cresmech,

There is actually an instrument driver available on ni.com/idnet for your instrument.  If you don't have a lot of experience with using instrument drivers, the Instrument Drivers help page will get you started. 

Thanks,

Meghan
Applications Engineer