02-14-2011 09:35 AM
I have downloaded the drivers for the Spartan 3E starter board for both 2009-1020 and 8.6 and I can't
get either one to work. They work up until the point where thwy need to communicate with the
Spartan board and then I get an error, I think it's a COBS error of some type.
Thanks,
Dave Ward ward@suu.edu
04-06-2011 07:52 AM
Dave,
What OS are you using (version and 32-bit or 64-bit), what cable are you using to hook up to the board, and the specific error code would be helpful as well.
BradM
02-28-2012 07:32 PM
I thik the problem is why the driver in not for labview 8.6
05-22-2012 10:23 PM
Good day,
Can the link for the Xilinx SPARTAN 3E Starter Board driver for LabView 8.6 be available again?
05-23-2012 09:30 AM - edited 05-23-2012 09:31 AM
I believe the installler located here may support 8.6 (don't have 8.6 installed to verify), note however that it is still subject to the same restrictions on use (namely, only for academic purposes)
05-24-2012 09:28 AM
Thank you so much
05-24-2012 10:37 AM
<-- If you'd like to actually thank me, there's a "Kudos" button over there...
08-30-2013 12:19 AM
Hi all,
Could I do something on spartan 3e kit board with LabVIEW 2013, I can not communicate with it via 2013 labivew version,
thanks a lot!
01-17-2014 04:23 AM
Hey hey!
I think I've arrived late to the forum cause all the links to get the spartan 3E starter board driver for LabVIEW 8.5 are not available anymore...I would really appreciate it if anybody would post it again 🙂
Thanks a lot!
Have a nice day!