05-23-2013 10:37 AM
Hy ,
First of all i'm new in multisim,i have this circuit wich should be a metal detector.
I hope its done correctly.How can i now if the board its done correct?Can i simulate it,and how?
I tried,but i think something its not done wright.
A little help
Sorry for my bad english.
Thanks
05-23-2013 01:26 PM - edited 05-23-2013 01:28 PM
05-27-2013 09:28 AM
Hello,
How to test this? You wouldn't be able to simulate it going near metal, maybe try to replicate the effect that would set off the alarm in a metal detector (some kind of signal, pulse, circuit, etc). As for your VCC, normally you don't use alternating current to run timers or components. I would use a DC power source between 5 to 12 V.
Regards,