09-28-2012 08:44 AM
This simulation runs fine but then suddenly stops! Can anyone shed any light on why this may be?
Solved! Go to Solution.
09-28-2012 12:15 PM
Hi,
I did not find that the simulation stops. I found that it significantly slows down when output of XFG1 goes low. This event appears to cause some difficulties for the simulator. Loosening the convergence tolerances helps. Go to Simulate->Interactive simulation settings->Analysis options->Customize. I suggest the following settings:
ABSTOL=1e-8
VNTOL=1e-4
RELTOL=0.01
Thanks
10-08-2012 01:20 AM