11-05-2012 03:35 AM
Solved! Go to Solution.
11-07-2012 03:09 AM
Hi Peric,
I want to help you out with your request.
What do you mean with incremental and absolute signals and how do you want to communicate with the EnDat Sensor?
Regards,
Joaquin
11-07-2012 04:31 AM
Hi Petric,
sorry for the questions, it's clear what you mean now. After some researches i can tell you, that it is the best solution to use the EnDat Signals is the cRIO EnDat Modul of SEA. National Instruments doesn't offer EnDat Modules, because we can't cover the whole spectrum of Modules and the EnDat Protocoll/Signal is very special and complicated. It ensures you reliable FPGA speed at a maximum data rate of 38 kHz and is a qualified product which is full supported from our cRIO Chassis. So if you want to use the EnDat Signal i would recommend you the Module from SEA. If it's possible to use other Signals like SSI, Hiperface you can look after other solutions.
EnDat 2.2 - Bidirectional Interface for Position Encoders
I hope I could help you with your question.
Kind Regards,
Joaquin
11-07-2012 05:01 AM
11-07-2012 05:18 AM
Manual for the EIB741 interface.
11-08-2012 12:54 AM
Thanks for the information. It's no what I hoped to hear but when the protocoll is so complicated, it seems to be the only good solution to get the cRIO Module from SEA...
11-08-2012 12:57 AM
thank you unclebump for your idea with the interface but we don't want an additional part in our controller box...