10-23-2008 07:02 AM - edited 10-23-2008 07:02 AM
Hi All,
I'm trying to find some properties such as "Data Transfer and Memory " in my "DAQmx Channel" property node, as below
But, in my Labview 8.5, I can't find it. I re-installed NI-DAQmx, but it didn't work. What I can get is
Did I miss something? Thank you.
Regards,
Bo
Solved! Go to Solution.
10-23-2008 07:10 AM
Hi,
I too had faced the problem but after a fresh installion of LabView 8.5 and Drivers. It worked.
10-23-2008 07:29 AM
Hi Akshath,
Thank you for the quick reply. I'll try that. (Once it works, I'll set your reply as Kudos) Thanks!
Regards,
Bo
10-23-2008 11:07 AM
I uninstalled all the NI software, and re-installed LabVIEW and DAQmx again, but sadly it didn't work. Thanks any way. But is there some other suggestion?
Best wishes,
Bo
10-23-2008 11:22 AM
Hi, Bo,
May be you should configure DAQmx card in Measurement and Automation Explorer?
Unfortunately I haven't DAQmx card right now in my PC, so, its just an idea...
best regards,
Andrey.
10-23-2008 11:29 AM
Hi Andrey,
Thank you for your reply. But I tried this on another computer on which lv 8.6 was installed, and it worked. I just simply dropped the channel property node, and didn't connect with any channel vi, and there were available options on that one. But for this pc, it doesn't work. I also configured the hardware in Mea & AE, it didn't help.
btw, my labview is full licenced.
Best wishes,
Bo
10-23-2008 11:59 PM
Hi
So now the better way is to call NI Support and explain the problem.
10-24-2008 04:17 AM
Hi Bo,
Take at look at this knowledge base article.
Let me know if this solves your problem.
Regards
John P
Applications Engineer
National Instruments
10-24-2008 05:32 AM