Why can't I find "Data Transfer and Memory " option in channel property node?

[foolooo]

Hi All,

I'm trying to find some properties such as "Data Transfer and Memory " in my "DAQmx Channel" property node, as below

But, in my Labview 8.5, I can't find it. I re-installed NI-DAQmx, but it didn't work. What I can get is

Did I miss something? Thank you.

Regards,

Bo

Message Edited by foolooo on 10-23-2008 07:02 AM

[AHK]

Hi,

I too had faced the problem but after a fresh installion of LabView 8.5 and Drivers. It worked. 

[foolooo]

Hi Akshath,

Thank you for the quick reply. I'll try that. (Once it works, I'll set your reply as Kudos) Thanks!

Regards,

Bo

[foolooo]

I uninstalled all the NI software, and re-installed LabVIEW and DAQmx again, but sadly it didn't work. Thanks any way. But is there some other suggestion?

Best wishes,

Bo

[Andrey_Dmitriev]

Hi, Bo,

May be you should configure DAQmx card in Measurement and Automation Explorer?

Unfortunately I haven't DAQmx card right now in my PC, so, its just an idea...

best regards,

Andrey.

[foolooo]

Hi Andrey,

Thank you for your reply. But I tried this on another computer on which lv 8.6 was installed, and it worked. I just simply dropped the channel property node, and didn't connect with any channel vi, and there were available options on that one. But for this pc, it doesn't work. I also configured the hardware in Mea & AE, it didn't help.

btw, my labview is full licenced.

Best wishes,

Bo

[AHK]

Hi

So now the better way is to call NI Support and explain the problem. 

[John.P · Accepted solution]

Hi Bo,

Take at look at this knowledge base article.

AE KB 3ESBHEL2: Missing Properties in DAQmx Property Nodes

Let me know if this solves your problem.

Regards

John P

Applications Engineer

National Instruments

[foolooo]

Yes, it works! Thanks a lot!

Regards,

Bo