06-20-2008 12:43 AM
I am deploying a teststand sequence using LabVIEW adapter. After deploying, while running this sequence in operator interface in the deployment computer, I get an error saying that a particular step could not be loaded. This step calls a DIO initialization VI which basically uses DIO Port Config.vi from Traditional DAQ 7.4.4 version. Please see the attached image.
Software Versions Used: Teststand 4.0.1f1, LabVIEW 8.5, Traditional DAQ 7.4.4, Simple OI shipped with Teststand, windows XP
From couple of links from www.ni.com, I did following actions in my development computer:
1. Compile All the VI in
2. Check if any VI or step is not broken.
After getting the error, I tried opening the same sequence in sequence editor in deployment computer (I am also including sequence editor with the deployment utility), I checked DIO Initialization step. I see the warning in step indicating that the VI is either broken or one of its sub is not located. I tried using Reload VI Prototype, it asks for LVDAQ.dll which is also bundled in my deployment files. After specifying this dll, I can run this sequence without errors but after I exit from sequence editor, it does not save the changes and I get the same error in Operator interface as well in sequence editor after re launching. Also I dont want to reload VI prototype as I dont expect some to do this change after deploying the testsequence.
Kindly help.
Thanks in advance.
Nirmal
06-23-2008 01:54 AM
06-23-2008 01:55 PM